Eco1 Dust Collector

ROTATIONALLY MOLDED I – RM 500 to 1,800 CFM Dust Collector

Key Advantages

Lightweight construction — no roof support reinforcement or structural supports required. The resulting savings may pay for the unit.
No painting required.
Completely prewired — saves installation and wiring time and expense. Included in warranty package.
Easy filter access — saves cleaning and replacement time and hassle.
Dimensionally compact units — easiest filtration model to fit into limited space.

Low density rotationally molded polyethylene body is rated for service from -20 to 250 degrees F.
Corrosion resistant polyethylene bin vent features 3/8" wall thickness with flanged body sections and is designed for up to 1,500 CFM at 4:1 air to cloth ratio.
Lightweight components, completely assembled —industry standard powder coated metal or stainless steel.
Nine 6-inch diameter, top loading pleated filters. 250 or 350 square feet of filter area (1 meter or 1.5 meter length).
Three valves with row pulse cleaning and solid state on-demand timer.
Single row pulsing limits backflow of air during cleaning.
Compact construction — easy to handle.
Snap band top load filters for easy access and minimal maintenance.

Spool piece for 1.5 meter filter and 1,800 CFM capacity.
Control panel with fan starter and disconnect, all pre-wired in Nema 4 or 4x enclosure. Available with and without VFD on fan.
Stainless steel trim.
Hopper is molded with 65° angle.
Grounded unit. Low-static feature available.
Custom fitting of fans, hoppers and unload accessories.
Bin vent or complete dust collection unit available.
Structurally designed for seismic zone 4 with 3' to 5' clearance standard.