Eco-2 Dust Collector

ROTATIONALLY MOLDED II – RM 450/1000 Dust Collector

Key Advantages

Increased size and capacity and lightweight construction. Like the RM250, no roof support reinforcement or structural supports are required. The resulting savings may pay for the unit.
No painting required.
Completely prewired — saves installation and wiring time and expense. Included in warranty package.
Easy filter access — saves cleaning and replacement time and hassle.
Choice of pleated or standard bags, depending upon the product being filtered. Body for 8' or 10' bags can be done.

Low density rotationally molded polyethylene body is rated for service from -20 to 250 degrees F.
Four filter configurations provide 16, 21, 26 or 37 filters for air flows from 1,500 to 5,000 CFM.
Corrosion resistant polyethylene bin vent features 1/2" wall thickness with molded flanged body sections.
Lightweight components, completely assembled — industry standard powder coated metal or stainless steel.
Four or five valves with row pulse cleaning and solid state on-demand timer.
Five foot diameter body.
Single row pulsing limits back flow of air during cleaning.
Snap band top load filters for easy access and minimal maintenance.

Choice of 16, 21, 26 or 37 filter configurations.
Custom fitting of fans, hoppers and unload accessories.
Bin vent or complete dust collection unit available.
Structurally designed for seismic zone 4 with 3' to 5' clearance standard.
Control panel with fan starter and disconnect, all pre-wired in Nema 4 or 4x enclosure. Available with or without VFD on fan.
Stainless steel trim.
Hopper is molded with 65° angle.
Grounded unit. Low-static feature available.

For more information contact:

HarmonDistributing@Eco-Blast.Com

9300 SW Burnham St

Tigard, OR 97224-7719

Office/Voice Mail: 503-653-5571

Office/Fax: 503-922-1278

Toll Free: 877-735-7943

www.Eco-Blast.Com

HarmonDistributing@Eco-Blast.Com